Guides:MAME - Software - NeXTSTEP - 3.3

From Wah!ki
Revision as of 22:51, 11 March 2021 by Sairuk (talk | contribs)
Jump to navigation Jump to search

Note dump

  • Must load device drivers disk first for other peripherals
  • When prompted for the cd scsi driver choose ?????

"To install NEXTSTEP on an IDE hard disk, use your computer's setup program to make sure the IDE controller and hard disk are enabled. Also, set your CD-ROM drive to SCSIID 2, 3, 4, 5, or 6 (some SCSI adapters don't work with CD-ROM drives set to SCSI 10 0 or 1)."

  1. just wait at boot:
  2. 1 for english
  3. 1 to prepare to install
  4. Select 3.3_Driver_Disk.img, Return
  5. See CDROM Section
  6. 1 to continue
  7. UI starts


CDROM

in theory it should be possible to install NeXT from an IDE CDROM, but i've been running into issues. The manual says a SCSI CDROM is required but I can see it assign the ATAPI drive to sd0 and then wait for it to become ready, just never does. The SCSI emulation in MAME is currently incomplete


Attached as a SCSI CDROM

  1. 1 for 154x SCSI for CDROM ISA
  2. Select 3.3_Beta_Drivers.img, 8, Return
  3. Select 6 for IDE Device Driver


^-- does not work .... sadness, gets stuck on Registering EISA


Attached as an IDE CDROM (SCSI dev is ignored)

  1. 4 for Adapter 2940 (ref: https://hackernoon.com/installing-nextstep-on-vmware-fusion-5c5c3e4442f4)
  2. When prompted for HDD, Select 3.3_Beta_Drivers.img, 8, Return
  3. press 7, Return
  4. Press 2 to select “Primary/Secondary (Dual) EIDE and ATAP Device Controllers”, Return
  5. This will find both the HDD and CDROM devices

^--- does not work ..... Fails on 

sd0: MAME Virtual CDROM 1.0
sd0: Waiting for drive to become ready
sd0: Dsk Not Ready
....
root on sd0
vfs_mountroot: error=15
panic: (Cpu 0) vfs_mountroot: cannot mount root


References

Retrieved from "https://wahki.mameau.com/index.php?title=Guides:MAME_-_Software_-_NeXTSTEP_-_3.3&oldid=4141"